Accessories and Parts for Fireplaces, Gas Log Heating Equipment
Air Conditioners Portable
Blue Flame Gas Wall Space Heater, Infrared Plaque Gas Wall Space Heater
B Vent Fireplaces
Chimney Pipe for Fireplaces and Stoves
Contemporary Collection
Direct Vent Fireplaces
Electric Fireplaces Modern Electric Fireplaces
Fireplace Categories, Gas Logs, Gas, Woodburning Fireplace
Fire Pit Outdoor Gas Firepits
FMI Vantage Hearth IHP Gas Fireplace, Gas Logs, Wood Burning Fireplace
Gas Log Sets, Vented and Vent Free
Grand Canyon Gas Logs
Grills, Freestanding, Built-In, Portable
Hargrove Premium Products
Majestic Fireplaces
Majestic Gas Logs
Outdoor Fireplace Gas and Wood Burning Outdoor Fireplace
Portable Heating Products
ProCom Vent Free Blue Flame Infrared Radiant Heaters
R H Peterson American Fyre Designs Fire Pit Tables and Urn
R H Peterson Real Fyre Fireplace Gas logs
Stoves Cast Iron Stove Gas and Wood Burning Stove
Sun Star Outdoor Heaters Patio and Construction
Sun Star Vent Free Infrared Radiant Flame Gas Heater
Superior Fireplaces
Vantage Hearth FMI IHP Gas Fireplace, Gas Logs, Wood Burning Fireplace
|
| | |
|
| |
| | |
|
|
On and Off Remote and Receiver with White Wall Plate F2236 RCKIT4001
 On and Off Remote and Receiver with White Wall Plate F2236 RCKIT4001 On and Off Remote and Receiver with White Wall Plate F2236 RCKIT4001 |
|
Suggested Retail Price: $101.00
Your Discount Price: $89.96
You Save: $11.04 (11 %)
Order Today and Save
Item Number: F2236
Manufacturer: Superior
Manufacturer Part #: RCKIT4001
|
|
On and Off Remote and Receiver with White Wall Plate F2236 RCKIT4001
This remote control system was developed to provide safe, reliable, and user-friendly remote control system for gas heating appliances.
The system can be operated manually from the transmitter. The system operates on one of 255 settable security codes on the
transmitter and receiver.
The transmitter has ON and OFF functions that are activated by pressing either
button on the face of the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates briefly to verify that a signal
has been sent. Upon initial use, there may be a delay of three seconds before
the remote receiver will respond to the transmitter. This is part of the system’s
design. If the signal light does not illuminate, check the position of the
transmitter’s battery.
The transmitter has (2) code switches located on the back that will need to be set
when installation is complete. Note: Code setting section
The transmitter operates on (1) 3V Button Cell (Included) that powers the RF
signal. Before using the transmitter the 3-volt battery must be installed into the
battery compartments.
Remove the battery holder from the bottom of the transmitter insert the 3-volt
button cell battery in the battery holder with the plus (+) side up. Note the drawing
at the left.
It is recommended that a CR2032 lithium battery always be used for longer
battery life and maximum operational performance.
|
Product Reviews
|
|
|