MD300TBABB 30,000 BTU ProCom Blue Flame Vent Free Dual Fuel Heater includes Blower and Base

MD300TBABB 30,000 BTU ProCom Blue Flame Vent Free Dual Fuel Heater includes Blower and Floor Mount Base

Vent-Free Gas Space Heaters Blue Flame Heaters
ProCom’s Blue Flame Vent-Free Gas Space heaters make supplemental heating fast and easy! Just push a button for easy ignition, stand back and enjoy a great source of dependable, affordable heat. These Blue Flame gas heaters heat the air first, circulating the warmth through the room, much like your central heating system.  

Enjoy the comfort and warmth of safe, clean-burning Heat, including factory installed blower fan and thermostat
Heats 600-1000 square feet. Includes factory installed blower fan, thermostat, push button ignition.

Operates without electricity during power outages - this heater is an excellent heat source during uncomfortable winter periods because the heater still heats when the electrically powered blower is inoperable.

Safety is an important factor with any heat source and this radiant heater, has a built-in low oxygen shut-off sensor (ODS system) that shuts the unit down if it ever detects a possible problem.

Easy to install. Tools required: Phillips screwdriver and pipe wrench. Base Mount kit and wall mount bracket options are both included with the heater.

Model No:

MD300TBABB 30,000 BTU Blue Flame Dual Fuel Gas includes Blower and floor mount feet (2) included

Description:
• 30,000 BTU Heats Up To 1,000 Sq. Ft.
• Patented DUAL FUEL TECHNOLOGY
• 1 Unit operates off Natural Gas or Liquid Propane
• Available in Thermostatic Models Only   
• Thermostatic Control - 5 Variable Heat Settings
• Space saving design without sacrificing beauty
• Economical: 99.9% efficient. No outside duct or chimney needed!
• Safety Assurance: O.D.S. (Oxygen Depletion Sensor) included with automatic shut-off, internal, non-adjustable regulator to prevent over firing
• No electricity required
• Push button Piezo ignition
• Product Dimensions: 23 1/2” H x 26 5/8” W x 8” D
• 2 year limited warranty

•Heats up to 1000 sq. ft.
•Includes factory installed blower fan and thermostat
•Battery operated electronic ignition
•Net Weight: 31 lbs.
Clearances to combustible items: above: 36" Side: 10-1/2" Below: 2"
Ventilation Required: Vent-Free  
Maximum Altitude: 4,500 feet

Floor or wall mountable (wall mount bracket and floor mount feet (2) included)   

Built in blower included
Electrical power required for Blower Fan Only: 110v/60Hz 1 Amps
Requires 3/8" NPT male inlet connection
Works with household standard inlet natural gas pressures between 9" and 14" WC
Works with standard propane pressures between 11" and 14" WC
100lb or larger propane tank is required on propane model
99.9% efficient design requires no duct or outside venting, so all the heat stays in the room.   

Vent-Free heater provides easy, economical installation, with no vent or chimney required.     

A dual purpose safety pilot system protects against oxygen depletion and any interruption in the fuel supply. If either occurs, the gas is shut off to the burner, turning the heater off.     

Provides heat during power outages.   

Easy to read digital temperature display
6" WC NG Regulator or 10" WC LP Regulator
2 Year Limited Warranty
CSA/AGA certified

IMPORTANT:
Use with adequate air (ventilation) only. Humidifies while it heats.   

Provides water vapor in the area heated. Refer to owner’s manual for specifics.
Product cannot be converted between fuel types.
Installation must be done by qualified service persons.
Read Owner’s Manual before using.
Check local codes and ordinances for permitted uses.
Vent-free gas products are prohibited for use in bathrooms, bedrooms or recreational vehicles installation in Massachusetts.
All products approved for manufactured (mobile) home installation.
We reserve the right to amend product specifications without notice.
Operating heater at very high elevations could cause nuisance outages.

This item cannot be shipped to California, Check local codes and ordinances for permitted uses.

Normal lead time is 48 Hrs