HST45 NG/LP Heatstar Overhead Tube Garage Shop Heater By Enerco

Front Fixed Hanger Provides rigid support and mounting surface for the reflector. Holes are provided in the upper corners of the Bulkhead to accommodate suspension hardware required for installation of the heater.

Reflector The reflector is made from formed aluminum and reflects the radiant energy downward to the space to be heated.

Heat Exchanger A U-shaped tube through which the heated products of combustion pass.

Rear Movable Hanger Provides support for the heat exchanger and reflector at the end that is furthest from the burner box.

The support may be moved (within limits) to accommodate hanging of the unit.

Service Door to be removed only by a licensed contractor. Removal of this service door provides access to the electrical and gas distribution components.

Intake Vent Accommodates a 3" diameter combustion air inlet duct that delivers fresh air to the burner.

Exhaust Vent Accommodates the air-venting duct that carries the products of combustion to be vented outdoors.

Nipple – ½ NPT Point at which the gas supply is connected to the heater.

Power Cord Includes a three prong plug that must be connected to a dedicated and properly grounded three prong ceiling outlet.